Rockwell Automation 23C PowerFlex 400 AC Drive Packages for Fan & Pump Apps - Manual (Page 178)

178 Rockwell Automation Publication 23C-IN001B-EN-P - June 2013
Chapter 3 Mechanical Installation
Lifting and Mounting the
Drive Care should be used to prevent damage due to dropping or jolting when moving
the drive. A fork lift truck or similar means of lifting and transporting may be
used. Sling in a manner that will equalize the load at the pickup points. Use a
spreader bar if the angle of the sling is less than 45 degrees relative to horizontal.
Do not jolt while lifting.
Figure 148 - Lifting the Drive
Use the following procedure to lift and mount the drive.
1. Attach a sling with safety hooks or clevis clamps to the two lifting holes.
Make certain that the angle of the sling is not less than 45 degrees relative
to horizontal.
2. Using an overhead or portable hoist, attach a free-fall chain to the chain
secured to the drive. Take up any vertical slack in the chain.
3. Using the hoist, lift the drive from the horizontal shipping pallet.
4. Position the drive.
5. Attach the drive to a vertical surface using the mounting holes provided.
Use washers under the bolt heads.
DRIVE OFF HAND AUTO MOTOR TEST BYPASS DRIVE
MOTOR
BYPASS RUN
SEE DRIVE DISPLAY FOR DRIVE STATUS
READY
PURGE
D O C
DRIVE
DIC
OL
BYPASS TRIP
BC
OUPUT
ENABE DRIVE
Lifting Hole 45˚ Min.
Front View Right Side View
INTERLOCK
OPEN