Rockwell Automation 5720 DriveLogix System - Manual (Page 63)

Publication 20D-UM002C-EN-P - November 2003
Placing and Configuring the Drive 3-5
Electronic Keying
Electronic keying has no effect on drive module. However, the default setting
(Compatible Module) is recommended.
Selecting “Compatible Module” allows you to enter the drive firmware minor
revision.
Revision
You must enter the correct drive VPL firmware revision, in order to launch
DriveExecutive Lite and create the appropriate links for the selected
communication format. Determine the firmware revision by viewing
parameter 314 [VPL Firmware Rev] in the drive.
IMPORTANT
You must select the correct voltage rating for the drive,
when adding the drive. You can find this on the drive data
nameplate.
The selection you make for the Comm Format
determines the communication format for the
connection to the drive. This determines the tag names
and data types. See page 3-6. Once you complete
adding a module, you cannot change this selection.
3. Configure the drive. Use the module properties wizard to specify characteristics for the module. Click Next
4. Click finish when you are done. The completed module appears in the Controller Organizer.