Rockwell Automation 20-COMM-I Interbus Adapter - Manual (Page 13)

Getting Started 1-5
This section is designed to help experienced users start using the
Interbus adapter. If you are unsure about how to complete a step, refer to
the referenced chapter.
Quick Start
Step Refer to
1 Review the safety precautions for the adapter. Throughout This
Manual
2 Verify that the PowerFlex drive is properly
installed. Drive User
Manual
3 Install the adapter.
Verify that the PowerFlex drive is not powered. Then,
connect the adapter to the network using an Interbus
cable and to the drive using the Internal Interface
cable. Use the captive screws to secure and ground the
adapter to the drive. Chapter 2 ,
Installing the
Adapter
4 Apply power to the adapter.
The adapter receives power from the drive. Apply
power to the drive. If there is a problem, refer to
Chapter 7 , Troubleshooting .
Chapter 2 ,
Installing the
Adapter
5 Configure the adapter for your application.
Set the parameters for the following features as
required by your application:
• I/O configuration.
• Fault actions.
Chapter 3 ,
Configuring the
Adapter
6 Apply power to the Interbus master and other
devices on the network.
Verify that the master and network are installed and
functioning in accordance with Interbus standards,
and then apply power to them.
7 Configure the scanner to communicate with the
adapter.
Use a network tool for Interbus to configure the
master on the network. Chapter 4 ,
Configuring the
Interbus Scanner
8 Create a ladder logic program.
Use a programming tool to create a ladder logic
program that enables you to do the following:
• Control the adapter and connected drive.
• Monitor or configure the drive using Explicit
Messages.
Chapter 5 , Using
I/O Messaging
Chapter 6 , Using
Explicit
Messaging (PCP
Communications)
20COMM-UM007A-EN-P.book Page 5 Tuesday, January 22, 2002 10:52 AM