Weidmuller WI-MOD-945-E: 900Mhz Wireless Ethernet & Device Server v2.16 - Manual (Page 93)

Weidmuller Wireless Ethernet Modem & Device Server WI-MOD-945-E User Manual
Page 93 www.weidmuller.com Rev 2.136
4.9 - Internal Diagnostic Modbus Registers
There are a number of internal diagnostic registers that can be accessed via Modbus TCP/RTU that will help with
analysing and diagnosing the radio network. To access these register the Modbus Server will need to be enabled and a
Modbus Server address will need to be configured (See 3.14 -
“Modbus I/O Transfer” for details on how this is done).
After enabling the Modbus Client you can then access the following information by reading the corresponding Modbus
Address at the Server ID address.
Note: ‘wi0’ is the normal default interface. If more interfaces are added by entering in virtual WDS
connections (either Client or AP) in section 3.16 - Repeaters (WDS) then they will take on the next
available interface number i.e. wi1, wi2, etc
Connection Information
Register Module Description
5000 Both Total number Associated Stations
5001 Both Current Radio Channel. See section 3.1 - “Selecting a Channel” for
channel details
5002 Both Number Wireless Interfaces configured, includes Virtual Interfaces –
wi1-wi10
5010 Both Wireless Adaptor (wi0) - Link Status
5011 Both Wireless Adaptor (wi0) - Link Status Inverted
5012 Both Wireless Adaptor (wi0) - Number Associated Stations for this interface
5013 AP Only Wireless Adaptor (wi0) - Points to the starting register of the AP's
Station List. First interface (wi0) will always start at 5200 and
dynamically enter data depending on the number of STA’s. Remaining
interfaces (wi1-wi10) will be entered after wi0 data. Register 5023,
5033, etc will indicate starting location for each interface.
5014 STA Only Wireless Adaptor (wi0) – RSSI & BGND of Rx message from AP e.g.
Hex 5F5D = 5D for RSSI and 5F for BGND (Convert value from hex to
dec and add a “-“ e.g. 5F = -95dB)
5015 STA Only Wireless Adaptor (wi0) - Transmit Data Rate from the Access Point
5016 STA Only Wireless Adaptor (wi0) - MAC Address of the Access Point
5020-5026 As per 5010-5016 As per registers 5010-5016 but for the next Wireless Adaptor (wi1)
5030-5036 As per 5010-5016 As per registers 5010-5016 but for the next Wireless Adaptor (wi2)
5040-5046 As per 5010-5016 As per registers 5010-5016 but for the next Wireless Adaptor (wi3)
……etc As per 5010-5016 As per registers 5010-5016 but for the next Wireless Adaptor (wi10)
5200 AP Only RSSI of the Client (STA)
5201 AP Only Transmit Data Rate to Client (STA)
5202 AP Only MAC address of Client (STA)
…..etc AP Only Dynamic list of STA's Refer to register 5023, 5033, etc for starting
register of each wi interface
9999 Both Reset module (enter FFFF to reset module)