Weidmuller WI-MOD-945-E: 900Mhz Wireless Ethernet & Device Server v2.16 - Manual (Page 109)

Weidmuller Technologies Wireless Ethernet Modem & Device Server 945U-E User Manual
Page 109 www.weidmuller.com Rev 2.136
JPerf Application
Jperf is a graphical interface that runs over the top of Iperf. It will display a graph result from the Iperf test.
To run Jperf open a CMD prompt and change to the “jperf-2.0.2: directory and run the “Jperf” application as shown in
Figure 86. The CMD screen will disappear and the Jperf Screen will appear as seen in Figure 87.
Figure 86
Figure 87
When Jperf screen appears select Client Mode, enter in IP address of the Server PC; leave Port as default and press Run
Iperf button. The test will run again and the Bandwidth (Throughput) display will show results of the test.
Note: Jperf runs using Java technology and depending on PC setup further installation of Java software may be required.