Weidmuller WI-MOD-945-E: 900Mhz Wireless Ethernet & Device Server v2.16 - Manual (Page 26)

Weidmuller Wireless Ethernet Modem & Device Server WI-MOD-945-E User Manual
Page 26 www.weidmuller.com Rev 2.136
Method 1 - Set PC to same network as WI-MOD-945-E
Connect the Ethernet cable between unit and the PC configuring the
module.

Set the Factory Default Switch to the SETUP position. This will
always start the WI-MOD-945-E with Ethernet IP address
192.168.0.1XX, subnet mask 255.255.255.0, gateway IP
192.168.0.1 and the radio disabled. Do not forget to set the
switch back to the RUN position and restart the module at the
conclusion of configuration for resumption of normal operation.

Power up the WI-MOD-945-E module.
 Open “Network Settings” on your PC under Control Panel. The
following description is for Windows XP - earlier Windows operating systems have similar settings.
 Open “Properties” of Local Area Connection.

Select Internet Protocol (TCP/IP) and click on Properties.

On the General tab enter IP address 192.168.0.1, Subnet mask
255.255.25
5.0 and press “OK”

Open Internet Explorer and ensure that settings will allow you to
connect to the IP address selected. If the PC uses a proxy server,
ensure that Internet Explorer will bypass the Proxy Server for local
addresses.

This option may be modified by opening Tools -> Internet Options -
> Connections Tab -> LAN Settings->Proxy Server -> bypass proxy
for local addresses.

Enter the default IP address for the WI-MOD-945-E 192.168.0.1XX
where XX is the last two digits of the serial number.

Enter the us ername “user” and default password “user”.
Figure 11 - Local Area Connection
Figure 12 - TCP/IP Properties