Weidmuller WI-MOD-945-E: 900Mhz Wireless Ethernet & Device Server v2.16 - Manual (Page 12)

Weidmuller Wireless Ethernet Modem & Device Server WI-MOD-945-E User Manual
Page 12 www.weidmuller.com Rev 2.136
1.1 - Getting Started Quickly
Most applications for the WI-MOD-945-E require little configuration. The WI-MOD-945-E has many sophisticated features,
however if y
ou don’t require these features, this section will allow you to configure the units quickly.
First, read Chapter 2, “Installation”. The WI-MOD-945-E requires an antenna and a power supply.

Power the WI-MOD-945-E and make an Ethernet connection to your PC (for further information on how to do this,
refer to section 3.2 -
“ Configuring the Unit for the first time”

Set the WI-MOD-945-E address settings as per section 3.2 - “ Configuring the Unit for the first time”

Save the configuration - the WI-MOD-945-E is now ready to use.
Before installing the WI-MOD-945-E, bench test the system. It is a lot easier to locate problems when the equipment is
altogether.
There are other configuration settings, which may or may not improve the operation of the system. For details on these
settings, refer to section 3.0 -
“Start-up”.