Aiming pointer, Aiming duration timer, Aiming pointer aiming duration timer – Wasp Barcode WDI4600 2D Product Reference Guide User Manual
Page 82: Default
Enter/Exit Programming Mode
Reading Parameters
72
WDI4600
Aiming Pointer
Enables/disables the aiming pointer for all symbologies.
$CTAAP00(CR)
Aiming Pointer = Disable
$CTAAP01(CR)
Aiming Pointer = Enable
DEFAULT
Aiming Duration Timer
Specifies the frame of time the aiming pointer remains on after decoding a label, when in trigger
single mode.The range for this setting is from 1 to 255 seconds in 1-second increments. See
in “References” for a description of this feature.
DEFAULT
LSTM00
Aiming Off After Decoding
LSTM
Set Aiming Duration Timer
To configure, scan the ENTER/EXIT PROGRAMMING
MODE barcode above, then the barcode at left followed
by the digits from the Alphanumeric characters in
representing your desired char-
acter(s). End by scanning the ENTER/EXIT barcode.
Make a mistake? Scan the CANCEL barcode to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL