Wasp Barcode WDI4600 2D Product Reference Guide - Manual (Page 191)

Data Matrix Enter/Exit Programming Mode
Product Reference Guide 181
Data Matrix Length Control
This feature specifies either variable length decoding or fixed length decoding for this
symbology.
Variable Length: For variable length decoding, a minimum and maximum length may be set.
Fixed Length: For fixed length decoding, two different lengths may be set.
DEFAULT
$CDMLC00(CR)
Data Matrix Length Control = Variable Length
$CDMLC01(CR)
Data Matrix Length Control = Fixed Length
Data Matrix Set Length 1
Specifies one of the barcode lengths for Data Matrix Length Control . Length 1 is the minimum
label length if in Variable Length Mode, or the first fixed length if in Fixed Length Mode.
Characters can be set from 0001 to 3,116 characters in increments of 0001 (pad with zeroes).
See page 217 for detailed instructions on setting this feature.
$CDML1
Select Data Matrix Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE barcode above, then the barcode at
left followed by the digits from the Alphanumeric char-
acters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
barcode again.
Make a mistake? Scan the CANCEL barcode to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT 0001 = Length 1 is 1 Character