Wasp Barcode WDI4600 2D Product Reference Guide - Manual (Page 59)

Data Format Enter/Exit Programming Mode
Product Reference Guide 49
Individually Set Label ID
This feature configures a Label ID individually for a single symbology. To set, first define
whether you want it as a prefix or suffix by scanning a label below. Then turn to
Label ID
Symbology Selection • 1D Symbologies, starting on page 50 to select the symbology you want
to set, followed by up to 3 characters from the ASCII Chart at the back of this manual. See
"
Label ID: Set Individually Per Symbology" on page 224 for detailed instructions on setting this
feature.
Label ID Control
This option controls whether a Label ID is disabled, or sent as a prefix or suffix for a given
symbology type.
DEFAULT
$CIDCO00(CR)
Label ID Transmission = Disable
$CIDCO01(CR)
Label ID Transmission = Enable as Prefix
$CIDCO02(CR)
Label ID Transmission = Enable as Suffix