Wasp Barcode WDI4600 2D Product Reference Guide - Manual (Page 77)

Reading Parameters Enter/Exit Programming Mode
Product Reference Guide 67
Stand Operation
Specifies the behavior of the reader when stationary in a stand. When configured for Stand
Mode, the reader will switch to Stand Mode when stationary.
Below are further options concerning Stand Operation.
Ignore Autorecognition. Disables mode switching when the reader is placed in a stand.
Switch to Stand Mode. Automatically switches the reader to Stand Mode when the reader is
placed in the stand.
Switch to Flashing. Automatically switches the reader to Flash Mode when the reader is placed
in the stand.
Switch to Always On. Automatically switches the reader to Always On mode when the reader is
placed in the stand .
$CSMSD00(
CR)
Do Not Change Mode
$CSMSD01(
CR)
Change to Stand Mode
DEFAULT
$CSMSD02(CR)
Change to Always On
$CSMSD03(CR)
Change to Flashing