Sensaphone 1800 - Manual (Page 98)

Sensaphone 1800 Manual
96
ALARM ACKNOWLEDGMENT
Alarm Acknowledgment—Voice Dialout
Repeated below is the same example of what the 1800 might say
during a typical “voice” dialout:
“Hello, this is 555-2278, ‘Acme Warehouse at 3rd and Chestnut
Streets,’ Zone One, ‘Temperature in refrigerator one,’ alarm exists,
temperature too high, it is now 45 degrees F.”
“Hello, this is 555-2278, ‘Acme Warehouse at 3rd and Chestnut
Streets,’ Zone One, ‘Temperature in refrigerator one,’ alarm exists,
temperature too high, it is now 45 degrees F.”
“Hello, this is 555-2278, ‘Acme Warehouse at 3rd and Chestnut
Streets,’ Zone One, ‘Temperature in refrigerator one,’ alarm exists,
temperature too high, it is now 45 degrees F.”
“Enter acknowledgment code.”
The 1800 will now wait 5 seconds for a Touch-Tone
acknowledgment code to be entered. After the last digit of the
acknowledgment code has been received, the 1800 will respond by
saying: “Alarm Acknowledged.” The alarm has been acknowledged
and the unit will hang up. Once the alarm has been acknowledged,
the dialout process stops.
If a Touch-Tone acknowledgment code is not received, the 1800
will offer you a second chance to enter it, responding with: “beep,”
“error,” “Enter acknowledgment code.” If the acknowledgement
code is still not received, then the 1800 will respond by saying:
“beep,” “error,” “goodbye.” The alarm has not been acknowledged.
The 1800 will hang up and wait for a callback acknowledgment.
This waiting period is called the “intercall delay time.” During
this time you may call the unit back from a Touch-Tone phone and
the unit will give a voice report. Once you receive the complete
report, enter the code to acknowledge the alarm. NOTE: An alarm
cannot be acknowledged using a pulse (rotary) telephone unless the
Callback Acknowledgment feature is enabled.
Alarm Acknowledgment—Numeric Pager Dialout
The 1800 will dial out to your pager service and leave a number
on the display of your beeper. (See Programming, Ch. 5) The unit