Sensaphone 1800 - Manual (Page 126)

Sensaphone 1800 Manual
124
APPENDIX F: 1800 Quick Reference Guide
Communications
ID Number Identification number of the 1800
[SET] or [WHAT IS] + [ID/POWER]
Range=0–16 digits, Default=blank
ID Message Custom message identifying the 1800
[SET] or [WHAT IS] + [MESSAGE] + [ID/POWER]
Max:6 seconds Default=N/A
Zone Message Message identifying the zone in alarm
[SET] or [WHAT IS] + [MESSAGE] + [zone #]
Max:3 .75 seconds Default=N/A
Voice Repetitions Number of times alarm message is repeated over the phone
[SET] or [WHAT IS] + [VOICE REPS]
Min: 1 reps, Max: 10 reps Default=3 reps
Dial-Out Phone Numbers Phone numbers dialed to report alarm conditions
[SET] or [WHAT IS] +[PHONE NUMBER] + [number 1–8]
Max: 8 numbers, 48 digits each Default=N/A
Call Delay Time delay until first call is made
[SET] or [WHAT IS] + [CALL DELAY] (min:sec)
Min: 00:00 Max: 60:00 Default=00:30
Intercall Time Time delay between phone calls
[SET] or [WHAT IS] + [INTERCALL TIME](min:sec)
Min: 00:10, Max: 60:00 Default=01:00
Max Calls Number of calls until unit self-acknowledges
[SET] or [WHAT IS] + [MAX CALLS]
Min: 0 calls, Max: 255 calls Default=100 calls
(TAD) Answering Device Allows 1800 to bypass answering devices on the same line
Compatibility [SENSOR ON/OFF] + [RINGS/TAD/*]
On or Off, Default=Off
Rings Until Answer Number of rings until unit answers an incoming call
[SET] or [WHAT IS] + [RINGS/TAD/*]
Min: 1 ring, Max: 15 rings DEFAULT=4 rings
Speaker Mute Turns off the speaker during alarm conditions
[SENSOR ON/OFF] + [MESSAGE/MUTE]
On or Off Default=Off
Call Progress Disables call progress detection feature
[SENSOR ON/OFF] + [STATUS/CONFIGURE]
On or Off Default=On