Sensaphone 1800 User Manual

Page 65

Chapter 5: Communication Programming

The 1800 will recite the type of call (voice, pager, alphanumeric
pager) and the number programmed. If there is no number
programmed, 1800 will say “No number.”

Numeric Pager Dialout

When programming the 1800 to dial a Numeric pager there are two
methods that can be used:

Automatic

mode and

Manual

mode.

The only difference is that in Automatic mode the 1800 will
automatically try to sense when the call has been answered and then
send the ID Number and alarms. In some instances, the automatic
answer detection and timing from the 1800 is incompatible with the
paging service, and the Manual mode must be used.

NOTE: If your phone system requires you to dial a

‘9’ followed by a pause to get an outside line, you
must use

Manual mode and insert the pauses at the

end of the number.

When the 1800 calls your Numeric Pager it will leave the
programmed ID Number along with the Zone number that is in
alarm. To acknowledge the alarm you will have to call the unit
back and enter an acknowledgement code, otherwise the unit will
continue dialing the remaining numbers.

To program a NUMERIC PAGER using AUTOMATIC

Mode:

1. Press the SET key

2. Press the PHONE NUMBER key.

3. Select which Phone number to program. Press any unassigned

number key (keys 1–8) to represent the new telephone number
entry. 1800 will respond: “Enter number.”