Sensaphone 1800 - Manual (Page 26)

Sensaphone 1800 Manual
24
CALL DELAY
1
VOICE REPS
2
INTERCALL TIME
3
MAX CALLS
4
LOW LIMIT
5
HIGH LIMIT
6
CALIBRATE
7
REC TIME
8 9
ID POWER
0 TABLE RANGE
#
PHONE
NUMBER
T/P
SENSOR
ON/OFF
WHAT IS
SET
MESSAGE
MUTE
OUTPUT DATE/TIME CODE
RINGS
TAD
*
LISTEN TIME
SOUND
TEST
°F/°C
HISTORY ENTER
LOCK
STATUS
CONFIGURE
A L A R M S
Zone 1
Zone 2
Zone 3
Zone 4
Zone 5
Zone 6
Zone 7
Zone 8
Sound
Power
Battery OK
Output On
Phone In Use
System On
ALARM
CANCEL
SENSAPHONE ® 1800
™
Figure 4: Typical connections from 1800
TURNING THE 1800 ON
Plug the unit’s transformer into a 120VAC 60Hz outlet. Toggle the
power switch to ON to start the unit. The System-On LED should
glow steadily and the unit will say “Hello.”
Note that when the unit is turned off, all programming is retained in
non-volatile memory.
Backup Battery
The Sensaphone 1800 includes a 12V 2.2AH sealed lead-acid gel-
cell rechargeable battery for system back-up in the event of a power
failure. The battery will provide approximately 12 hours of backup
time. Actual backup time will depend upon the temperature, battery
age, and dialing activity. The battery is located behind the main
panel.