RKI Instruments Eagle 2 - Manual (Page 102)

98 • Detail Settings Button
While the pre-defined gases may not be edited, the 1 user-
defined gas may be edited by doing the following:
1. With Data Logger Management Program running, click on
the Set button to display the Set window. Click the Detail
Settings button to display the Detail Settings window. Click
on the PID Sensor tab and then click on the High Range tab.
2. If no user-defined PID gas has been previously defined for
the connected instrument, the name and long name will both
appear as PID for the High Range and Low Range tabs. The
full scale, digit, and factor values will appear as shown in
Table 4 below. The rest of the fields will contain asterisks
(*****).
Table 4: Default Values for User Defined PID Gas
Full Scale (ppm) Digit Factor
High Range 2000 2 1.00
Low Range
50.00 0.02 1.00
Figure 80: High Range Tab