Instruction sheet – Prescolite AKTCLS User Manual

Page 3

701 Millennium Blvd, Greenville, SC 29607

With representatives offices in principal cities throughout North America.

Instruction

Sheet

www

.pr
escolite.com

Pr
escolite T

oll Fr

ee T
echnical Support

1.888.PRS.4TEC

Hours: 8am-5pm ET

701 Millennium Blvd, Greenville, SC 29607

With representatives offices in principal cities throughout North America.

Part Number 02371500

TWO CIRCUIT INSTALLATION
1. Connect circuit one black supply wire to line side of one switch. Secure with approved connector
2. Connect supplied black jumper wire from switch, wired to circuit 1, to L-1 terminal on track feed connector
3. Connect circuit one neutral supply wire to N-1 terminal on track feed connector
4. Connect circuit two hot supply wire to line side of remaining switch. Secure with approved connector
5. Connect supplied black jumper wire from switch, wired to circuit 2, to L-2 terminal on track feed connector
6. Connect circuit two neutral supply wire to N-2 terminal on track feed connector
7. Connect ground wire to ground screw

CANOPY INSTALLATION

1. Align cutouts to slide canopy over junction box as shown in diagram. If installing with AKTSL and/or second switch,

remove the appropriate scored tab.

2. Secure canopy to junction box with supplied tamper-resistant

screws, using bit driver provided to tighten screws.

NOTE: IN ORDER TO MEET CALIFORNIA TITLE 24

REQUIREMENTS, CANOPY MUST BE SECURED
WITH VANDEL RESISTANT SCREWS PROVIDED.

OPERATION

After installation is complete, place current limiter switch
in the “on” position to power track. If current draw of
installed heads exceeds maximum ratings on the current
limiter, limiter will automatically switch to “off” position.
If this occurs, reduce the wattage/current draw on the
track to a wattage/current draw lower than the maximum
ratings allowed on the current limiter. Turn current
limiter switch back in the “on” position.

Green Ground Screw

White (Neutral) Wire N2

Black (Hot) Wire L2

Black (Hot) Wire L1

White (Neutral) Wire N1

AKTEF or AKTSL

(ordered separately)

AKTCLS

Current Limiter Switch

6-32x3/8” Pinned Torx
Security Screw