Prescolite 4/6SQLED - Manual

1
2
3
4
Instruction
Sheet
www.prescolite.com
•
Prescolite
TollFree
Technical
Support
1.888.PRS.4TEC
•
Hours:
8am
- 5pm
ET
701 Millennium Boulevard • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2012, 1/26/12 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 93038535
Instruction
Sheet
INSTALLATION INSTRUCTIONS
LITEFRAME ® LF4/6SQLED AND 4/6SQLED
1. Install the fixture in the ceiling using hanger
bars (supplied), or mounting channel or bar
(by others) placed in the adjustable mounting
brackets. Mount the fixture in the ceiling so that
the weight of the fixture is supported by the
hanger bars, mounting channel, bar, and/or
hanger wires secured to the building structure.
2. Adjust the fixture so the bottom of the plaster
flange is flush with the finished ceiling line and
in alignment with adjacent fixtures. Secure
mounting brackets by tightening wing nuts on
either side of the fixture.
3. Determine where the supply wiring conduit will
enter the J-Box and attach it in conformance
with the National Electric Code.
4. Remove J-Box cover plate. Remove appropriate
knockout and assemble appropriate connector
for the supply wire used. Connect ground wires
to green ground leads. Connect white (common)
to white (leads). Connect power supply (line) to
black lead(s). Reinstall J-Box cover.
WARNING: DO NOT pinch wires
between J-Box/ballast cover and J-Box.
Consult a qualified electrician for all
other options that require other wiring
configurations.
5. Pull electrical cover (1) down through opening in
fixture. (SEE FIG 1)
6. Squeeze two torsion springs (2) together and
insert ends into two brackets (3). (SEE FIG 1)
7. Insert connector (4) into driver and snap electrical
cover (1) onto driver assembly. (SEE FIG 1)
8. Push trim assembly up towards ceiling until
springs draw trim firmly against ceiling. (SEE
FIG 1)
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information and
instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials, and
proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and during
servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other poten-
tial hazard. Product must be mounted in locations and at heights and in a manner consistent with its
intended use, and in compliance with the National Electrical Code and local codes. The use of accessory
equipment not recommended by the manufacturer or installed contrary to instructions may cause an unsafe condition. Do
not block light emanating from product in whole or part, as this may cause an unsafe condition. Do not allow items such
as drapes, curtains, screens or the like to come into contact with the product or to block light from the product, as this may
cause an unsafe condition.
WARNING - This product contains chemicals known to the State of California to cause cancer, birth defects and/or other
reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
CAUTION: DO NOT ATTEMPT TO MODIFY OR REWIRE FACTORY-INSTALLED WIRING ON THE FIXTURE. SAFETY AND
PROPER OPERATION OF THE FIXTURE DEPEND ON THE INTEGRITY OF THE WIRING.