Prescolite 6LFLED WW - Manual

Instruction
Sheet
www
.prescolite.com
Prescolite T
ollFree T
echnical Suppor
t
1.888.PRS.4TEC
Hours: 8am - 5pm ET
701 Millennium Blvd, Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2010, 9/20/10, All Rights Reserved - Printed in U.S.A.
Part No ....................................................... 93029237
Sheet 1 of 1
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information and instructions
concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials, and proper lamping. Do
not install in areas subject to combustible vapors or gases. Before wiring to power supply and during servicing or relamping, turn
off power at fuse or circuit breaker. All servicing or relamping must be performed by qualified service personnel.
Product must be grounded to avoid potential electric shock or other potential hazard. Product must be
mounted in locations and at heights and in a manner consistent with its intended use, and in compliance
with the National Electrical Code and local building codes. The use of accessory equipment not recommended by the
manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from product in
whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or the like to come into
contact with the product or to block light from the product, as this may cause an unsafe condition.
WARNING - This product contains chemicals known to the State of California to cause cancer, birth defects and/or other
reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
1. Install the fixture in the ceiling using hanger bars (supplied), or mounting channel or bar (by others) placed in the adjustable
mounting brackets. Mount the fixture in the ceiling so that the weight of the fixture is supported by the hanger bars,
mounting channel, bar, and/or hanger wires secured to the building structure.
2. Adjust the fixture so the bottom of the plaster flange is flush with the finished ceiling line and in alignment with adjacent
fixtures. Secure mounting brackets by tightening wing nuts on either side of the fixture.
3. Determine where the supply wiring conduit will enter the J-Box and attach it in conformance with the National Electric
Code.
4. Remove J-Box cover plate. Remove appropriate knockout and assemble appropriate connector for the supply wire used.
Connect ground wires to green ground leads. Connect white (common) to white (leads). Connect power supply (line) to
black lead(s). Reinstall J-Box cover.
WARNING: DO NOT pinch wires between J-Box/ballast cover and J-Box. Consult a qualified electrician for all other options
that require other wiring configurations.
5. Pull electrical cover (1) down through opening in fixture.
6. Insert connector (2) into module (5) and snap electrical cover (1) onto module (5) inside of two spring clips (6).
7. Remove two hex nuts (3) and insert brackets
(7) on module onto two pem studs making sure
that module is facing as shown in diagram.
Install two hex nuts (3) using a nut driver and
Tighten down while holding module against
Bracket.
8. Squeeze two torsion
springs (8 together and insert ends into
two brackets (9).
9. Push trim assembly up towards ceiling
until springs draw trim firmly against ceiling.
INSTALLATION INSTRUCTIONS
LITEFRAME ® LF6LED WW AND 6LFLED WW
NOTES: UNLESS OTHERWISE SPECIFIED
1. DEBURR AND BREAK SHARP CORNERS.
2
1
3
7
8
6
5
4
9
* *
*
cwilson 09/17/10
--- --/--/--
--- --/--/--
PV:1
4 3 2 1
A A A
B
4 3 2 1
A
B
B