Prescolite LBC6W Wall Mount User Manual

Instruction sheet

www.prescolite.com

•

Prescolite

TollFree

Technical

Support

1.888.PRS.4TEC

•

Hours:

8am

- 5pm

Instruction

Sheet

Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 93041497

Instruction

Sheet

LBC6W Wall Mount Installation Instructions

NOTE: In compliance with Underwriters Laboratories Standard UL 1570, 1571, or 1572; the use of a silicone base caulking

compound must be used to provide a watertight seal between fixture & mounting surface to prevent electrical wiring from

getting wet.

CAUTION: DO NOT ATTEMPT TO MODIFY OR REWIRE FACTORY-INSTALLED WIRING ON THE FIXTURE. SAFETY AND PROPER

OPERATION OF THE FIXTURE DEPEND ON THE INTEGRITY OF THE WIRING.

KEEP THESE INSTALLATION INSTRUCTIONS

1. Detach mounting plate from cylinder bracket by loosening set screw.
2. Secure mounting plate to wall/J-Box with screws provided by others.
3. Connect black and white fixture wires to the respective black and white

supply wires with wire nuts. Attach fixture and supply ground wires to

ground screw on mounting plate

4. Hang fixture on mounting plate by the mounting plate stud.
5. Tighten set screw to secure fixture to the mounting plate.

IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information and instructions con-

cerning Wet or Damp Locations, installation near combustible materials, insulation, building materials, and proper lamping. Do not install

in areas subject to combustible vapors or gases. Before wiring to power supply and during servicing or relamping, turn off power at fuse or

circuit breaker. All installation servicing or relamping must be performed by qualified service personnel. Product must

be grounded to avoid potential electric shock or other potential hazard. Product must be mounted in locations and

at heights and in a manner consistent with its intended use, and in compliance with the National Electrical Code

and local codes. The use of accessory equipment not recommended by the manufacturer or installed contrary to instructions may cause

an unsafe condition. Do not block light emanating from product in whole or part, as this may cause an unsafe condition. Do not allow items

such as drapes, curtains, screens or the like to come into contact with the product or to block light from the product, as this may cause an

unsafe condition.

701 Millennium Boulevard • Greenville, SC 29607

With representatives offices in principal cities throughout North America.

WARNING- This product contains chemicals known to the State of California to cause cancer, birth defects and/or

other reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this

product.

CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK, MAKE CERTAIN THAT THE

POWER IS OFF BEFORE INSTALLING OR SERvICING THIS FIXTURE

MOUNTING PLATE
STUD

SET SCREW

GROUND SCREW

MOUNTING
PLATE