Instruction sheet – Prescolite SDPSCFT User Manual

Page 2

www

.prescolite.com

• Prescolite

TollFree

Technical Support

1.888.PRS.4TEC

• Hours: 8am - 5pm ET

101 Corporate Drive • Spartanburg, SC 29303

With representatives offices in principal cities throughout North America.

Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .143690100

Instruction

Sheet

5. PUSH THE SPLICES INTO THE J-BOX. HOLD UP THE

FIXTURE WHILE DOING THIS TO REDUCE SLACK ON

THE BLACK AND WHITE WIRES.

6. PUSH CHAIN AND GREEN BRACKET GROUND WIRE

INSIDE COVER.

7. ALIGN SIDE HOLES ON COVER TO SIDE HOLES ON

MOUNTING BRACKET AND FASTEN WITH FLAT HEAD

SCREWS SUPPLIED.

8. INSTALL THE DESIRED REFLECTOR AFTER ALL CEIL-

ING INSTALLTION AND FINISHING WORK IS COM-

LETE.

*SEE INSTRUCTION SHEET 1077-**** FOR DPR8 &

DPR10 SERIES REFLECTORS.

*SEE INSTRUCTION SHEET 1079-**** FOR DPRL &

DPRVML SERIES DIFFUSERS.

9. INSTALL THE DESIRED LAMP (BY OTHERS).

INSTRUCTIONS FOR LAMP POSITIONING

THERE ARE 3 LAMP POSITIONS AVAILABLE FOR THIS

FIXTURE. THE FIXTURE IS SHIPPED AND INSTALLED

IN THE LOWEST (CLOSEST TO REFLECTOR APER-

TURE) POSITION.

THESE POSITIONS ARE DETERMINED BY AN

ADJUSTABLE BRACKET MECHANISM WITHIN THE

HOUSING. THE 57W VERSION ONLY HAS ONE LAMP

POSITION AVAILABLE.

10a. IF THE LAMP IS A 26W COMPACT FLUORESCENT

LAMP, DO NOT REPOSITION THE LAMP.

10b. IF THE LAMP IS A 32W COMPACT FLUORESCENT

LAMP, PLACE THUMBS AT BOTTOM OF LAMP AND

PUSH UP UNTIL BRACKET MECHANISM CLICKS

INTO MIDDLE POSITION.

10c. IF THE LAMP IS A 42W COMPACT FLUORESCENT

LAMP, PLACE THUMBS AT BOTTOM OF LAMP AND

PUSH UP UNTIL BRACKET MECHANISM CLICKS

INTO TOP POSITION.

11. TO REPOSITION THE LAMP TO A LOWER POSITION,

PULL DOWN ON THE CHAIN SHOWN IN THE LOWER

FIGURE. PUSH ON LAMP UNTIL IT IS IN THE NEW

POSITION (SEE STEPS 10a - 10c).

8-32 FLAT HEAD SCREWS

(SUPPLIED)

REFLECTOR NOT SHOWN FOR

EASE OF VIEW

CHAIN

SEE PAGE 3 FOR FIGURE OF FULLY

INSTALLED FIXTURE