Prescolite LITEBOX - Manual

w
w
w
.p
re
s
c
o
lit
e
.c
o
m
•P
res
co
lite
To
llF
ree
Te
ch
nic
al
Su
pp
ort
1.8
88
.P
RS
.4T
EC
•
Ho
urs
:8
am
-5
pm
ET
701 Millennium Blvd., • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2004, 08/04 revision, All Rights Reserved - Printed in U.S.A
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .01635200
Ins
tru
ctio
nS
he
et
INSTALLATION INSTRUCTIONS
FOR LITEBOX
1 2
3
Place Housing between joists, slide housing against joist
to be nailed, line up bottom of Bar Hanger with bottom of
joist and hammer integral nailers into joist.
Slide Housing against opposite joist and repeat process.
For suspended ceilings, locate notches on bottom of Bar
Hangers over T-Bar. Bend Bar Hanger foot toward
housing to lock onto T-Bar.
For narrow openings, disassemble Bar Hangers and insert one
Bar Hanger in each end of fixture, bend Bar Hanger at appropriate
length to fit between Joists, drive nailers into joists and use screw
through end of each slot on other side.
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.