Instruction sheet – Prescolite LFHSQL-H13_EB SERIES User Manual

Page 2

Instruction

Sheet

www

.prescolite.com

Prescolite T

ollFree T

echnical Suppor

1.888.PRS.4TEC

Hours: 8am - 5pm ET

701 Millennium Blvd, Greenville, SC 29607

With representatives offices in principal cities throughout North America.

Part No ....................................................... 93021227

Sheet 2 of 2

For Ballast replacement:

Note wire connections and remove ballast wire connectors. Loosen the (2) hex nuts holding the ballast to the Main
J-Box. Slide ballast toward opening in keyhole slots and lift ballast off J-Box. Replace ballast by following these steps in
reverse order.

CAUTION: Do not attempt to modify or rewire factory installed wiring on the fixture. Safety and proper operation of the fixture
depend on the integrity of the wiring.

The product must be installed by a person familiar with the construction and operation of the product and the hazards involved,
in accordance with the applicable installation code.

TRIM INSTALLATION: (Ordered separately)

Follow the instructions outlined above for installing the housing.

For DCB Option only: DCB Auxiliary Lamp leads must be connected to an auxiliary emergency power supply circuit
(provided by others). CAUTION: DCB circuit must be 120V only.

For QR/DCB Option only: After housing installation and wiring is complete, ensure that QR/DCB conduit assembly is
securely fastened to the access door. Install correct double contact bayonet base T4 quartz lamp and wattage per label
on access door.

Carefully install correct MH lamp per label in housing and install the trim by with mounting means supplied with the trim.

KEEP THESE INSTALLATION INSTRUCTIONS