Instruction sheet – Prescolite T6 User Manual

Page 2

www

.prescolite.com

• Prescolite

TollFree

Technical Support

1.888.PRS.4TEC

• Hours: 8am - 5pm ET

101 Corporate Drive • Spartanburg, SC 29303

With representatives offices in principal cities throughout North America.

Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .93003663

Instruction

Sheet

TO RE-LAMP THE FIXTURE FROM THE BOTTOM. (REFER TO THE DIAGRAM ON SHEET 1 FOR PART LOCATIONS).

1. VERIFY THAT THE POWER IS SHUT OFF TO THE FIXTURE!

2. REMOVE THE SELF-TRIM REFLECTOR.

3. REMOVE THE LENS BY DISENGAGING THE THREE RETAINING SPRINGS.

4. VERIFY THE CORRECT LAMP TYPE. A RE-LAMPING LABEL IS LOCATED INSIDE THE COWLING,

AND IS VISIBLE WHEN THE SELF-TRIM REFLECTOR IS REMOVED.

5. REMOVE THE OLD LAMP, AND INSTALL THE NEW LAMP.

6. RE-INSTALL THE LENS AND SELF-TRIM REFLECTOR.

RE-LAMPING FROM ABOVE: (REFER TO THE DIAGRAM ON SHEET 1 FOR PART LOCATIONS)

1. VERIFY THE POWER IS SHUT OFF TO THE FIXTURE!

2. LOCATE AND LOOSEN THE 3 SOCKET CUP SCREWS.

3. THE SOCKET CUP CAN THEN BE ROTATED UNTIL KEY HOLES ALIGN WITH SCREWS AND LIFTED UP FROM THE

MOUNTING FLANGE.

4. TURN THE SOCKET CUP OVER. THE LAMP IS NOW EXPOSED, AND CAN BE REMOVED AND REPLACED.

5. VERIFY THE CORRECT LAMP TYPE. A RE-LAMPING LABEL IS LOCATED ON THE TOPSIDE OF THE PLASTER FLANGE.

6. REMOVE THE OLD LAMP, AND INSTALL THE NEW LAMP.

7. RE-ATTACH THE SOCKET CUP BY REPLACING IT IN ITS ORIGINAL LOCATION AND ORIENTATION,

AND TIGHTENING THE 3 SCREWS.