Instruction sheet – Prescolite T4 Halogen Housings User Manual

Page 2

www.prescolite.com

•

Prescolite

TollFree

Technical

Support

1.888.PRS.4TEC

•

Hours:

8am

5pm

Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 93006268

Instruction

Sheet

TO RE-LAMP THE FIXTURE FROM THE BOTTOM. (REFER TO THE DIAGRAM ON SHEET 1 FOR PART LOCATIONS).
1. VERIFY THAT THE POWER IS SHUT OFF TO THE FIXTURE!
2. REMOVE THE SELF-TRIM REFLECTOR.
3. REMOVE THE LENS BY DISENGAGING THE THREE RETAINING SPRINGS.
4. VERIFY THE CORRECT LAMP TYPE. A RE-LAMPING LABEL IS LOCATED INSIDE THE COWLING,
AND IS VISIBLE WHEN THE SELF-TRIM REFLECTOR IS REMOVED.
5. REMOVE THE OLD LAMP AND WITHOUT TOUCHING THE GLASS WITH SKIN, INSTALL THE NEW LAMP.
6. RE-INSTALL THE LENS AND SELF-TRIM REFLECTOR.

RE-LAMPING FROM ABOVE: (REFER TO THE DIAGRAM ON SHEET 1 FOR PART LOCATIONS)
1. VERIFY THE POWER IS SHUT OFF TO THE FIXTURE!
2. ROTATE THE SOCKET CUP ASSEMBLY UNTIL RETAINING SPRINGS DISENGAGE.
3. THE SOCKET CUP ASSEMBLY CAN NOW BE LIFTED UP FROM THE HEATSINK.
4. TURN THE SOCKET CUP ASSEMBLY OVER TO EXPOSE THE LAMP.
5. VERIFY THE CORRECT LAMP TYPE. A RE-LAMPING LABEL IS LOCATED ON THE TOPSIDE OF THE PLASTER FLANGE.
6. REMOVE THE OLD LAMP AND WITHOUT TOUCHING THE GLASS WITH SKIN, INSTALL THE NEW LAMP.
7. RE-ATTACH THE SOCKET CUP ASSEMBLY BY ALIGNING THE FLATS WITH THE RETENSION SPRINGS AND TURNING
UNTIL SPRINGS ENGAGE.