Prescolite CFT/CFTD970HEB - Manual (Page 2)

www
.prescolite.com
• Prescolite
TollFree
Technical Support
1.888.PRS.4TEC
• Hours: 8am - 5pm ET
101 Corporate Drive • Spartanburg, SC 29303
With representatives offices in principal cities throughout North America.
Copyright 2005, 08/05 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .158510100
Instruction
Sheet
Reflector Bridge
Upper
Reflector
(1-Lamp
Reflector
Shown)
Wing Nut (3)
(Supplied W/
Housings)
Lens
Lower
Reflector
Install the Housing Per Instructions on Page 1
1. Reflector Istallation, 2-Piece Reflector:
Insert the two outer studs on the socket mounting bracket
through the matching holes in the top of the upper reflector.
Secure the reflector with the wing nuts supplied with the
housing.
2. Install the lamp(s).
3. Install the lower reflector by placing the reflector in the
plaster flange aperture. Push the reflector upwards until the
flange on the reflector is flush against the finished ceiling.
Allow the three reflector springs to retain the lower reflector
against the ceiling.