Instruction sheet – Prescolite SLLED3 User Manual
Page 3
CONDUIT
CONNECTION
HOUSING
GASKET
TYPICAL
DRY CONSTRUCTION
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .93017298
Instruction
Sheet
701 Millennium Blvd., • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2008, 9/12 revision, All Rights Reserved - Printed in U.S.A.
FIG. 6
HANGER
BRACKETS
MOUNTING
SCREWS
BRACKET
SUPPORT FRAME
(BY OTHERS)
HOUSING
Installation Instructions Recessed LED Aisle Light- SLLED 3
For Wet or Drywall Installation (Housing Installation)
For Wet or Drywall Installation
1. Use the hanger bar bracket which is sold seperately as
SLMB.
2. Remove screws from housing and use them to secure
brackets to housing shown in figure 4.
3. Slip bar hangers into brackets.
4. Hold housing in desired position and drive bars into studs.
If needed reinforce with nails or scews.
5. If desired, brackets can be mounted directly to framing
members as shown in FIG 5.
6. Run supply wires in accordance with local and national
electical codes.
FIG. 4
FIG. 5