Prescolite SLLED3 - Manual (Page 2)

GASKET
TYPICAL
CONDUIT
CONNECTION
HOUSING
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .93017298
Instruction
Sheet
701 Millennium Blvd., • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2008, 9/12 revision, All Rights Reserved - Printed in U.S.A.
Installation Instructions Recessed LED Aisle Light- SLLED 3
For Concrete or Masonry Installation (Housing Installation)
FIG. 2
FIG. 3
For Concrete Installation
1. Select a threaded hole in housing to
be used for supply wire access.
Insert plugs into threaded holes not
being used.
2. Attach housing with conduit mounted
to concrete form, Front surface of
housing must extend at least 1/8 inch
out from the surface of the wall.
3. Run supply wires in accordance with
local and national electrical codes.
(For drywall installation see figure 4)
For Masonry Installation
1. Select a threaded hole in housing to be used for
supply wire access. Insert plugs into threaded holes
not being used.
2. Remove one masonry brick from the wall at the
desired location for the fixture.
3. Insert the fixture housing into the wall and secure in
place with mortar. Front surface of housing must
extend at least 1/8 inch out from the surface of the
wall.
NOTE: IT IS RECOMMENDED THAT THE ALUMINUM HOUSING BE
COATED WITH AN ASPHALT PAINT CONTAING ALUMINUM PIGMENT.
NOTE: PRESCOLITE CONCRETE MOUNTING BOX P/N: SLD3CMB IS TO BE USED WITH SLLED3
HOUSINGS ONLY.