Prescolite SLLED2 - Manual (Page 3)

Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .93017297
Instruction
Sheet
701 Millennium Blvd., • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2008, 09/12 revision, All Rights Reserved - Printed in U.S.A.
HOUSING
CONDUIT
CONNECTION
DRY CONSTRUCTION
FACE OF HOUSING MUST BE
FLUSH OR PROTRUDE SLIGHTLY
FROM WALL FOR PROPER SEAL.
GASKET
TYPICAL
SCREWS TO MOUNT
HANGER BAR BRACKETS
FIG. 6
For Wet or Drywall Installation
1. Use the hanger bar bracket which is sold seperately as
SLMB.
2. Remove screws from housing and use them to secure
brackets to housing shown in FIG 4.
3. Slip bar hangers into brackets.
4. Hold housing in desired position and drive barbs into
studs. If needed reinforce with nails or screws.
5. If desired brackets can be mounted directly to framing
members as shown in FIG 5.
6. Run supply wires in accordance with local and national
electical codes.
Installation Instructions Recessed LED Aisle Light- SLLED2
For Wet or Drywall Installation (Housing Installation)
FIG. 4
CONDUIT
(BY OTHERS)
SUPPORT FRAME
(BY OTHERS)
HOUSING
3.87
HANGER
BARS
BRACKET
MOUNTING SCREWS
FIG. 5
(For concrete installation see figure 2)