MacDon PW7 Pick-Up Header - Manual (Page 64)

SECTION 7 – SERVICE
Form 169149 Revision E 58
7.5 DRIVE SHAFT INSTALLATION
WARNING: DO NOT begin to
perform any service procedure until
combine is lowered to the ground or
feeder house locks are engaged,
combine is shut off, the key is
removed and all moving parts have
stopped.
The drive shaft is to be installed after the
header/pickup is attached to combine. Installing
the drive shaft requires the following steps:
a) Engage the feeder house lock or lower the
header completely down.
b) Shut off engine and remove the key from the
ignition.
c) Take the clutch end of the drive shaft, pull
back the locking plate and slide it onto the
drive shaft of the header
d) Release the locking plate and continue
sliding it on to the header shaft until it clicks
into place. Pull back to ensure that drive
shaft is locked into place.
Drive Shaft to Header Installation
(Illustration May Differ)
e) Take the opposite end of the drive shaft,
pull on the quick disconnect slide collar
and slide it onto the shaft of the
combine.
f) Release the collar and continue sliding it
onto the combine shaft until the yoke
locks into place. Pull back to ensure that
drive shaft is locked.
Drive Shaft to Header Installation
(Illustration May Differ)
g) Attach both drive shield chains together.
h) Take the single chain clip and attach to
back of header.
Chain Clip Attachment
P00049
P00048
P00047