MacDon PW7 Pick-Up Header - Manual (Page 23)

SECTION 3 – SETUP COMPLETION
Form 169149 Revision E 17
LOCK HOOKS INTO ADAPTER FRAME
BOTH SIDES - Agco
H
G
E
F
h) Remove the hydraulic/electrical multi
coupler cover from the storage bracket.
i) Install the multi coupler from the feeder
house onto the header multi coupler.
j) This will automatically engage the wiring
and hydraulics.
Header Multi Coupler
Feeder house Multi Coupler in Storage
3.1.3 AGCO
a) Engage lower locking mechanism as follows:
Insert concave door tool (E) in latch socket
(F) and rotate latch clockwise to lock hooks
(G) into the adapter frame (both sides).
MAKE CERTAIN that the latch is rotated
over-center to securely lock the hooks. If it
does not latch, check to determine if the
lower pins (H) are seated in the adapter back.
If not, place a block under the left end of the
adapter and lower the adapter to reseat the
pins. Re-latch the hooks.