MacDon PW7 Pick-Up Header - Manual (Page 27)

SECTION 3 – SETUP COMPLETION
Form 169149 Revision E 21
3.3 FEEDERHOUSE WIDTH
CONVERSION
For John Deere, Case IH, New Holland and
Agco Combines, see the instructions supplied
with the mechanical completion package to
initially configure the header to suit your
combine. For Lexion combines, machines are
factory configured for narrow combine feeder.
Before use with a Lexion combine with wide
feeder house, the header must be reconfigured
using the supplied parts as follows:
Lexion – Narrow to Wide:
NOTE: These instructions can also be used to
convert a header configured for a John Deere
narrow feeder combine to a wide feeder house.
For Agco combines, see your dealer for
conversion instructions for the three available
feeder house widths.
a) Remove the two outer auger hand hole
covers to gain access to inside of auger.
b) Remove the auger flight extensions. These
are the innermost pieces of flighting on each
side of auger center.
c) Remove finger hole covers and add two
additional auger fingers and finger guides at
the next two open locations at both sides of
the auger (total of 4). These are shipped in
the document case at back of header.
d) Reinstall hand hole covers.
e) Remove lower stripper bar and stripper bar
extensions.
f) Move lower stripper bars outward one hole
so they are flush with combine feeder house
opening and bolt to the header floor.
Hand hole Covers
Flight extension
Extension bracket/bars