MacDon PW7 Pick-Up Header User Manual
Page 10
SECTION 2
SAFETY
Form 169149
Revision E
4
2.3
SAFETY DURING OPERATION
A) Extremity Lights
Extremity Light
Extremity Lights
The header comes with a left and right hand
extremity light that works in conjunction with
the flashing/signal combine lights. For bulb
replacement, see appropriate section in this
manual.
ATTENTION: Reflectors that are damaged
or worn are to be replaced immediately.
NOTE: Red and Orange Reflectors are visible
from the rear; amber is visible from the front.
New reflectors are available from your dealer.
B) Drive Shaft Safety
Shields are in place for your
protection. Replace any worn or
missing shields.
Drive shaft shields are to rotate
freely at all times (free from binding
while chained). Replace worn shield
bearings promptly.
Never operate header without
shields in place.
Never make modifications to the
drive shaft and shields.
ALWAYS store the drive shaft in
its storage holder. Never use safety
chains to support drive shaft.
DO NOT step on the drive shaft.
Any servicing to the drive shaft
must only be done when the header
is lowered to the ground or the
combine feeder house locks are
engaged, the machine is shut off,
the ignition key is removed and all
moving parts have stopped. Never
make adjustments to, or clean a
running combine.
Make sure drive shaft is attached
properly before operation.
Keep any loose fitting clothing,
jewelry, or long hair away from
moving parts, components, or
retainer chains.
P00542
P00541