MacDon PW7 Pick-Up Header - Manual (Page 3)

INTRODUCTION
Form 169149 Revision E I
In order to ensure that the header/pickup will operate smoothly and efficiently for years to come, it is
important that it be correctly set up and properly maintained. Windrow headers with pickup
attachments are designed to pick up windrows of agricultural products such as wheat, soybeans,
canola, barley, etc. and small seed pick ups, and are only intended for such use.
Contained in this manual are safety precautions, operating instructions, and service and maintenance
procedures for the PW7 Pickup Header, and Series IV Rake-Up and SwathMaster pickups. The units
covered in this manual are compatible with John Deere 50 Series and 60 Series combines, Case IH
Combines, New Holland Combines, Gleaner/Massey/Challenger Combines and Claas/Lexion
combines.
The following header sizes are covered in this manual:
13 foot
15 foot
The following pickup models are covered in this manual:
PICKUP SERIES IV ATTACHMENTS
Rake-Up
12’ Small Seed
14’
16’ SwathMaster
12’ Small Seed
14’
16’
Note: Left and right hand are referenced from the operator’s seat looking forward. The illustrations
in this manual may not match your exact machine.
We welcome your suggestions, questions or comments regarding the installation, operation or
maintenance of the header /pickup.
All printed publications are classified as uncontrolled documents and are subject to change without notice at the discretion of MacDon Industries Ltd.
Published: February 2013