Multiquip WRS5200DFPU (KUBOTA WG972-GL-E3 DUAL FUEL) - Manual (Page 51)

wrs5200dfpu hYdrauLIC roLLer sCreed • operatIon manuaL — rev. #0 (08/18/14) — page 51
10. Press the throttLe rocker switch upward (Figure 47)
on the control box and verify that the engine speed is
set to full speed mode, green light is on.
Figure 47. Throttle Switch (Green/Run)
startIng (Lpg mode)
1. Insert ignition key into ignition switch (Figure 42) and
turn key to the on position.
2. Press the gas/Lp gas rocker switch upward
(Figure 48) on the control box to select the LP Gas
mode, RED light is on.
Figure 48. Fuel Selector Switch (LPG Mode)
3. Verify that the throttLe is set to idle, no green
light (Figure 45).
THROTTLE
SWITCH
GREEN LIGHT
“ON” (RUN)
GAS/LPG
BUTTON
RED LIGHT “ON”
LPG MODE
oPeration
4. open propane tank gas valve (Figure 49). Turn valve
knob counterclockwise to open valve.
Figure 49. Propane Tank ON/OFF Valve (Open)
5. do not activate, press or use choke button (Figure 46)
while in LP Gas mode.
6. Repear steps 4 through 10 as outlined in the "Starting
Gas Mode" section. Do perform step 5.
NOTICE
never activate, press or use choke button while in
LPG mode, possible damage to the LPG vaporizer
may occur.
NOTICE
When the changing of gas modes is desired, (gas to
LPG) the engine must be stopped and the desired mode
selected via the Gas/LPG switch.