Multiquip WRS5200DFPU (KUBOTA WG972-GL-E3 DUAL FUEL) - Manual (Page 29)

wrs5200dfpu hYdrauLIC roLLer sCreed • operatIon manuaL — rev. #0 (08/18/14) — page 29
The definitions below describe the controls and functions
of the Power Unit (Figure 11).
1.
propane tank — Holds 33.5 lbs of propane when used
to fuel engine instead of gasoline.
2. Lifting Bail — Attach a chain, rope or strap to this
lifting bail whenever lifting of the power unit is required.
This bail is installed only on newer units. Make sure
lifting device has adequate lifting capacity for lifting
the power unit.
3. muffler — Required to reduce noise and emissions.
never touch muffler while it is hot.
4. emergency stop Button — In the event of an
emergency press this button. do not use this button
as a method of shutting down the unit. Pull button
outward when restarting.
5. Air Cleaner — Prevents dirt and other debris
from entering the fuel system. Replace with only
manufacturer recommended type air cleaner.
6. Engine — The unit uses a 32.5 HP Kubota gasoline/
propane engine. Reference engine owners manual or
maintenance section in this manual for engine care
and service.
7. hydraulic motor support Bracket — Place strike
tube hydraulic motor into this bracket whenever the
drive tube requires maintenance or disassembly. Insert
cotter-pin to keep motor from falling.
8. overflow Bottle — Fill with recommended type
coolant. Always maintain proper coolant level.
9. radiator/Cap — Fill with recommended coolant.
never remove radiator cap while engine is hot. Allow
a sufficient amount of time for radiator to cool before
removing cap.
10. Steering Handles — Use these handles (2) to steer
and position the power unit.
11. tires — This unit employs semi-pneumatic tires. The
power unit should never be towed on a highway.
Always replace tires with original size type tire. Tires
are designed to be puncture proof.
12. Battery — Provides +12VDC for power unit electronics.
Replace with recommended type battery only.
PoWer Unit comPonents
13. hydraulic reservoir tank/Cap — Remove this
cap to add hydraulic fluid. Fill with AW MV ISO 46
type hydraulic fluid. Reservoir capacity is 5 gallons
(19 liters).
14. Hydraulic Fluid Gauge — Displays the amount of
hydraulic fluid in the hydraulic tank. Also the gauge will
display the temperature of the hydraulic fluid.
15. Quick-disconnect Coupling (output) — Connect
hydraulic motor drive line to this output port. Make
sure to cover coupling with dust cap to prevent dirt
and debris from contaminating hydraulic fluid system.
16. Quick-disconnect Coupling (return) — Connect
hydraulic motor return line to this input port. Make
sure to cover coupling with dust cap to prevent dirt
and debris from contaminating hydraulic fluid system.
17. Halogen Lights — Power unit is equipped with four
50-watt halogen lights. Lights can be used when
working in dark areas or at night.
18. fuel tank — Fill with clean fresh gasoline. Fuel tank
capacity is 5 gallons (19 liters).
19. Fuel Gauge — Indicates the amount of gasoline in
the fuel tank.
20. Control Box receptacle — Insert the control box
power cable into this receptacle.
21. pressure washer (optional) — Removes excess
material.
22. Control Lever — 3-position lever, pressure washer,
neutral and screed operation.
23. fuse/relay Box — Replace with only recommended
type fuses or relays.
24. power relay/ fuse module — Design for high current
applications. Contains 20 and 60 amp fuses. 60 amp
fuse is switchable via relay.
25. propane tank Gas Gauge — Indicates the amount
of propane in the propane tank.
26. Igniter — Ignites the engine fuel mixture.