Memmert IFP 400 - 800 Incubators (Generation 2003) - Manual (Page 20)

PERFECT page 20
Programming example programme operation
The oven (UFP500) has to heat up as quickly as possible to 180°C on Monday at 08.00 hrs with a fan speed
of 50% and the air valve open 20%. The oven has to hold this temperature for 45 minutes with the air
valve 50% open, followed by cooling down in one hour to 60°C with fan switched off and the air valve
open 20%.
Mo 8:00h
0:45h
1:00h
0˚C
250˚C
200˚C
150˚C
100˚C
50˚C
˚C
t=time
1. Select operating mode “programme“
After holding down the SET key (approx. 3 sec) the current operating
mode is flashing. Hold down the SET key and select operating mode
“programme“ using the push/turn control.
After the SET key has been released the controller is in operating mode
“programme operation“.
PRINT SETUP
2. Edit programme
Hold down the SET key and turn the push/turn control to select ”EDIT”.
After the SET key has been released, the controller is in the programme
writing mode.
3. Weekday for delayed programme start
Hold down the SET key and turn the push/turn control to set the start
day Mo.
Mo
4. Select clock time for delayed programme start
Using the push/turn control, select the time display.
Hold down the SET key and set the time 08:00 using the push/turn
control.
h