Memmert IFP 400 - 800 Incubators (Generation 2003) - Manual (Page 17)

PERFECT
Muster
page 17
10 Programme operation
PRINT SETUP
In this operating mode, up to 40 freely programmable temperature-time ramps can be set. Rotating the
press/turn control while holding down the SET key selects the following parameters in sequence after
released the SET key:
- a new programme can be programmed or
an existing programme can be edited
EDIT
- stops the programme STOP
- starts the programme START
After EDIT has been activated, the following parameters can be selected and can be altered as
described in the Section “Selecting the parameters“:
PRINT SETUP
loop
t3
t4 t2
t1
on
off
Mo Tu We Th Fr Sa Su
°C
MAX
°C h
Delayed programme start: switch-on day
Range: Monday to Sunday, workdays Mo-Fr, weekend Sa-Sun, all days Mo-Su or no day. If no day of the
week is selected, the oven starts up immediately after the programme is started. ( instant start )
PRINT SETUP
loop
t3
t4 t2
t1
on
off
Mo Tu We Th Fr Sa Su
°C
MAX
°C h
Delayed programme start: switch-on time
Range: 00:00 to 23:59
If no switch-on day has been selected it is not possible to select a switch-on time, and the programme
starts immediately. ( instant start )