beautypg.com

2 product safety and dangers, 3 safety labelling – Memmert TTC 256 Temperature test chamber (Generation 2003) User Manual

Page 7

background image

7

Safety regulations

1.2

Product safety and dangers

Temperature test chambers of type TTC and climatic test chambers of type CTC are technically

advanced, manufactured using high-quality materials and are tested for many hours in the

factory. The test chambers are state-of-the-art technology and comply with recognised techni-

cal safety regulations. However, there are still dangers involved, even when the appliance is

used as intended. These dangers are described below.

Warning!

When opening the chamber door, hot steam may escape and scald

you. Remain behind the door when you open it and let out the

steam, or allow the test chamber to cool down before opening the

door.
Warning!

Depending on operation, the surfaces in the chamber interior, the

viewing window, the cable feed-through and the chamber load may

be very hot or very cold. You could suffer from burns or frostbite if

you touch these surfaces. Allow the chamber interior to first adjust

to room temperature after opening the door, or use heat-resistant

protective gloves.
Warning!

After removing covers, voltage-carrying parts may be exposed. You

may receive an electric shock if you touch these parts. Disconnect

the mains plug before removing any covers.
Any work inside the unit may only be performed by qualified electri-

cians.

Warning!

When loading the chamber with an unsuitable load, toxic or explo-

sive vapours or gases may be produced. This could cause the cham-

ber to explode, and people could be badly injured or poisoned. The

chamber may only be loaded with materials/test objects which do

not form any toxic or explosive vapours when heated up (see also

chapter 2.6 Intended Use on page 14 ).

1.3

Safety Labelling

The test chamber is provided with warning

stickers on the door to warn of dangerous

temperatures inside the chamber interior

( Fig. 1 ). These stickers must not be removed

and must always be well visible. If they

become unrecognisable or if they peel off,

they must be replaced. You can order the

stickers from Memmert customer service.

Fig. 1

Warning stickers

This manual is related to the following products: