Lenze Drive Server Bus server S7 getting started - Manual (Page 11)

Busserver S7
L
72 Busserver S7 DE/EN 1.0
3 Software installation
Proceed as follows to install the bus server software on your PC:
1. Start Windows.
2. Insert the “DriveServer with bus server S7” CD-ROM into your CD-ROM drive.
If the auto-start function of your CD-ROM drive is activated, the installation program will be
started automatically. If so, proceed with step 5.
3. Select Run... from the start menu.
4. Enter the letter for your CD-ROM drive followed by “ :\setup.exe” (e.g. ”e:\setup.exe“) and
confirm the entry by clicking OK.
5. Follow the instructions of the installation program.
Note!
Windows NT/ 2000/ XP
Installation under Windows NT/2000/XP requires administrators rights!
Windows 98
DCOM is not installed as standard in Windows 98 and must be installed separately, if necessary.
• The bus server installation program checks if DCOM has been installed and suggests to install
DCOM if DCOM is not available.
• The bus server software cannot be installed without DCOM.
Tip!
For notes about the DCOM configuration, please refer to the manual “DriveServer - Getting Started.”
Show/Hide Bookmarks