Lenze 931K - Manual (Page 68)

Appendix
Table of parameter numbers (PNU)
10
l
68 KHB 13.0004−EN 2.1
Characteristics Possible settings Name PNU
Description Selection Lenze
Name PNU
1011 Acceleration for
Velocity Control Ċ UINT32 RW Ċ
Setting the acceleration and
deceleration for the speed
control mode
0 Acceleration
Velocity Control
10000 0 {1 rpm/s} 20000 Acceleration, the value set is
valid for both directions of
rotation
l Reads out only the actual
value for the positive
direction of rotation
1 Deceleration
Velocity Control
10000 0 {1 rpm/s} 20000 Deceleration, the value set is
valid for both directions of
rotation
l Reads out only the actual
value for the positive
direction of rotation
2 All Accelerations
Velocity Control
10000 0 {1 rpm/s} 20000 Acceleration and
deceleration, the value set is
valid for both directions of
rotation
l Writes the value set to
PNU 1011, subindexes 0
and 1
l Reads out the actual value
for the positive direction
of rotation under
PNU 1011, subindex 0