Lenze HMI for visualisation / with control technology - Manual (Page 48)

Operation
Control Panel Applets
Registry
8
l
48 LDCDS−EL100 EN 9.0
8.2.2 Registry
)
Note!
The modifications of some Applets are automatically stored in the Registry
when you click OK (message "Saving").
The modifications of other Applets are not stored automatically in the
Registry, which means that they are lost after a restart. If you wish to make
permanent modifications to these Applets, proceed as follows:
ƒ Click Start
® Settings ® Control Panel ® Registry on your EL1xx.
ƒ Click Save.
EL100−024
Registry Editor: Opens the Registry Editor.
Save: Saves the Registry.
Restart Device: Restarts the EL 1xx.
Clean: After a restart, the Registry is reset to the default setting if this control field has been
selected.