Kinze 3000 Rigid Frame Planter Rev. 6/14 - Manual (Page 104)

M0188-01 Model 3000
6-34 Rev. 6/11
TM
KPM II Monitor Operation
NOTE:
See “Programming - Row Spacing” for
programming applicable row spacing.
See “KPM I/KPM II Stack-Mode Electronic
Seed Monitors Troubleshooting” in the
Troubleshooting Section.
STEP 3 Press the OK key. Row number starts
flashing.
STEP 4 Arrow UP or DOWN to desired row.
STEP 5 Press SELECT key. “AVG” starts flashing.
STEP 6 Arrow UP or DOWN to choose one of the
following options.
HIGH - For Early Alarm (70%)
AVG - For Standard Alarm Setting (55%)
LOW - For Failed Alarm Only (25%)
OFF - To Disable Row Alarm
STEP 7 Press and hold the OK key to save alarm
setting. There will be four short beeps, one
long beep and the word “DONE” will appear
when the save is completed.
STEP 8 Repeat STEPS 3 through 7 for each row on
which you wish to adjust the alarm setting.
STEP 9 When finished, press the SETUP key to
exit setup mode.
NOTE: The programming mode may be exited at
any time by pressing the SETUP key. Pressing this
key will return the monitor to its normal operation.
All items changed and saved will come into effect
immediately. Any items changed, but not saved
will revert to the original programmed value.
NOTE: Repeat STEPS 3 through 7 to change seed
monitor back to the original settings when special
row-by-row alarm level settings are no longer
required.