JUMO 706510 LOGOSCREEN 500 cf Operating Manual - Manual (Page 57)

57
3 Operation and visualization
3.10 Code number (password query)
The following functions are protected ex-factory against unauthorized access
by a password query:
- the Configuration menu
- parts of the CompactFlash card menu
- the Parameterization ➔ Reset counter / int. menu.
The factory default setting for the passwords is 09200.
You can also use a password to secure access to the recorder via one of the
interfaces (with the exception of the setup interface). However, the factory
default setting here is 0 (no password query). If you enter a value other than 0,
please take into account that this number must also be sent to the recorder by
an attached communications program.
All passwords can be programmed differently (see Chapter 4.2.2
“Configuration - Instrument (device) data”).
Password query
When you have finished the entry (e.g. +09200), use the E key to confirm
it. Use D if you want to cancel the password query and quit the menu.
H
Further information about the password query for the interfaces
can be found in the Interface description B 70.6510.2.0.
Increase (+1) or
decrease (-1) selected
digit Select the digit to
be altered