JUMO 706585 LOGOSCREEN fd Operating Manual - Manual (Page 173)

173
23 Configuration – Batches/Plants
23.2 General Plant Parameters
Overview
Number of
plants The parameter defines the number of plants for which a batch report will be
created.
Comment For concluded batches, the text that is entered is shown as a header for a text
of maximum length 400 characters, which is used to describe the batches
(recipe or similar).
Text left column
01 — 10 The parameters define the text in the left-hand column of the batch protocol.
The text is the same for all plants (batch reports).
v Chapter 4.9 "Batches/Plants"
0 Batch reporting is not active.
1 — 3 A batch report is created for each active plant.
H
The description cannot be entered on the device. Instead it must
be entered using the setup program or an interface (web server or
Modbus).