JUMO 706585 LOGOSCREEN fd Operating Manual - Manual (Page 169)

169
22 Configuration - Interface
22.4 Modbus/TCP
Overview
Timeout
monitoring Timeout monitoring can be activated in the event that recorder is run as slave
via Ethernet.
If active monitoring is the case then the communication between the slave (pa-
perless recorder) and the master with regard to the external analog and binary
inputs is monitored. If no communication takes place within the configured
time then an alarm message is displayed and entered into the alarm and event
list.
Timeout monitoring remains inactive after the recorder has been switched on
until the master sends the first query. That way, different switch-on and start-
ing times from the master and slave are compensated.
v Chapter 2.7 "Binary Signals"
v Siehe “Activate replacement value” auf Seite 124.
v Siehe “Activate replacement value” auf Seite 128.
Timeout Duration of timeout monitoring
Alarm text This text is displayed in the status bar in the event of a malfunction and en-
tered in the alarm and event list.
Yes Monitoring takes place.
No Monitoring does not take place.