JUMO 706585 LOGOSCREEN fd Operating Manual - Manual (Page 139)

139
18 Configuration - Groups
18.6 Normal Operation
Overview
Memory status Only if Memory status is switched on, is the operating mode “Normal
operation” available.
With activated normal operation, the measurement data will be recorded at the
storage cycle that was configured, unless
• event operation is active,
• timed operation is active or
• the parameter Stored values is configured for Eco mode.
Memory values This parameter determines how measurement data are recorded.
H
If Memory status is switched off and neither event nor timed
operation is active, only events are acquired but no measurement
data stored.
Average values The average value of the storage cycle that was set is
calculated and stored.
Current values The current value is stored at the storage cycle that was
set.
MIN values The minimum value is stored at the storage cycle that
was set.
MAX values The maximum value is stored at the storage cycle that
was set.
MIN/MAX values The minimum and maximum values (envelope) is stored
at the storage cycle that was set.