INFICON MDC-360C Thin Film Deposition Controller - Manual (Page 146)

MDC-360C DEPOSITION CONTROLLER
COMPUTER INTERFACE 11-4
5 Invalid message.
6 Process undefined. Can’t add layer.
7 Insufficient layer space. Can’t add layer.
8 Can’t send process log data while in process.
11.8 INSTRUCTION SUMMARY
The following table is a list of valid instruction codes.
Instruction Code Description
0 Remote activation of controller
1 Send controller configuration parameters
2 Send utility parameters
3 Receive utility parameters
4 Send controller time and date
5 Receive controller time and date
6 Send a material
7 Receive a material
8 Send a material list
9 Send number of undefined layers
10 Send a process
11 Receive a process
12 Delete a process
13 Send a process layer
14 Insert process layer
15 Replace a process layer
16 Delete a process layer
17 Send a process list
18 Send source setup
19 Receive source setup
20 Send sensor setup
21 Receive sensor setup
22 Send Input setup
23 Receive Input setup
24 Send Output setup
25 Receive Output setup
26 Send Action setup
27 Receive Action setup
28 Send controller status
29 Start process
30 Send run-time values
31 Initiate automatic data logging
32 Internal Command
33 Set Active Source Power
34 Internal Command
35 Internal Command