INFICON Front Load Single Sensor - Manual (Page 15)

1 - 5
PN
07
4-
15
6N
Front Load Single and Dual Sensors Operating Manual
1.4.2 Dual Sensor Configuration Overview and Parts
Front Load Dual Sensor . . . . . . . . . . . . . DL-AXXX, see Figure 1-3 .
Figure 1-3 Front Load Dual Sensor configurations
Thin Film Manuals CD . . . . . . . . . . . . . . . . . . . . . . . PN 074-5000-G1
Crystal Snatcher . . . . . . . . . . . . . . . . . . . . . . . . . . . . PN 008-007
78.1 cm (30.75 in.) In-Vacuum Cable . . . . . . . . . . . . PN 007-044
(standard length)
152.4 cm (60 in.) In-Vacuum Cable . . . . . . . . . . . . . PN 321-039-G13
(extended length)
Molybdenum Disulfide in Alcohol . . . . . . . . . . . . . . . PN 750-191-G1
Tube Bender Kit . . . . . . . . . . . . . . . . . . . . . . . . . . . . PN 750-037-G1
(provided only with non-welded sensors)
D L –
0
3
4
0
7
8
A
E
G
NOTE 1:
Orders for a WELDED sensor/feedthrough combination cannot
be accepted without a completed sensor length specification
form (provided by INFICON). Once a welded sensor order is
confirmed, it cannot be canceled.
NOTE 2:
Feedthrough configuration varies depending on options selected
(type of feedthrough and connection). Example: DL-AE37 uses
feedthrough PN 750-707-G1 while DL-AE48 uses feedthrough
PN 206-890-G2.
NOTE 3:
Sensor lengths are measured from center of the crystal closest
to the end of the sensor to the vacuum side (sealing surface) of
the feedthrough (see length specification form).
NOTE 4:
Front Load Dual Sensors ordered with a CF40 feedthrough
cannot be welded due to dimensional limits of the CF40.
NOTE 5:
For sensors ordered without a weld connection (option “0”
or “8”), tubes are made to a length of approximately 76.2 cm
(30 in.) for “E” length and approximately 121.9 cm (48 in.) for
“G” length sensors.
Operation with 152.4 cm (60 in.) in-vacuum cables requires
a monitor / controller with ModeLock technology (XTC/3, IC6,
Cygnus 2).
Type of Sensor
(Includes in-vacuum cables.
Crystals sold separately.)
Standard dual sensor
(water lines parallel to
crystal face) with shutter
Length of Sensor –
SEE NOTES 1 and 3
20.3 to 71.1 cm (8 to 28 in.)
includes two 78.1 cm (30.75 in.)
in-vacuum cables. SEE NOTE 5
Extended length –
71.1 to 121.9 cm (28 to 48 in.)
includes two 152.4 cm (60 in.)
in-vacuum cables. SEE NOTE 5
Feedthrough Connection
SEE NOTE 4
Sensor not connected to
feedthrough
Sensor welded to feedthrough
Feedthrough equipped with
Ultra-Torr
® compression fittings
(allows for adjustable sensor
length)
Feedthrough
SEE NOTE 2
None
1 in. bolt
CF40
Standard length –