INFICON Protec P3000(XL) Helium Leak Detector - Manual (Page 84)

4-29
Equipment Settings
k
in
a
26
e Ch
ap
te
r
4
.fm
Tech
ni
ca
l Ha
nd
bo
ok
(1
20
9)
Measure Background Press button
If pressing the MEASURE BACKGROUND button the
Protec P3000 will go into a special measurement
mode and determine the background concentration
of Helium currently prevalent in the environment.
This process may take a couple of seconds. This
feature is not a continuous signal display but should
be used for trouble-shooting purposes only.
Page 3: Sensor Errors
Sensor Error Hex Code
Sensor / Valve Warning Hex Code
Adjust Error Hex Code
Page 4: PRO-Check data
Gas Helium Gas type of internal leak
Leak rate nom. / at T mbar l/s / mbar l/s
Version / Checksum Hex Code
Serial no.
Serial no reservoir
Manufacturing date DD.MM.YYYY
Expiry Date DD.MM.YYYY
Gain / Offset
Test leak temperature °C / °F
State
Page 5: Sniffer data
Type
SL3000 / SL3000XL /
system
Software version x.x
Length 3m / 5m / 10m / 15m
Serial no. 9000 xxx xxxx
Switch left on / off
Switch right on / off
Color Green / red
Bar graph
Menu item Format Description